Page 1 of 1

Hat Greeble's

Posted: Sat Jan 10, 2015 5:14 pm
by Zachg56
So, I got a 3D printed greeble for an Imperial officer costume, and I'm just curious, what's the best way to put them on the caps? Or rather what's the most recommended thing to glue to the back of them so they can be attached to the cap?

Re: Hat Greeble's

Posted: Sat Jan 10, 2015 5:45 pm
by Ripcode
Post a pic of the greeblie. I'd like to see if it's approvable.

Re: Hat Greeble's

Posted: Sat Jan 10, 2015 6:36 pm
by Zachg56

Re: Hat Greeble's

Posted: Sat Jan 10, 2015 6:49 pm
by Ripcode
That looks like crap. :whatthe:

Are aluminum greeblies that pricey, that you would go the 3D printer version?

Re: Hat Greeble's

Posted: Sat Jan 10, 2015 6:51 pm
by Ripcode
Nope, not pricey at all. Just found them....

http://www.elvistrooper.com/disk.htm

Re: Hat Greeble's

Posted: Sat Jan 10, 2015 6:54 pm
by Zachg56
I went with the 3D cause it came with the hat I got...was wondering where the site was for the aluminum ones.

I'll get the new greeble soon, what's the best way to put it on though?

Re: Hat Greeble's

Posted: Sat Jan 10, 2015 7:42 pm
by Mr Fett
It tells you right in the link Ripcode just posted.

" they have a solid back so that you can glue a hatpin to the back of it for attachment to a cap or any other cloth item. "

Re: Hat Greeble's

Posted: Sat Jan 10, 2015 9:36 pm
by Zachg56
Ah...I did not see that